![]() ![]() One new option WinMax has that my boss is too cheap to buy is the Tool and Marital Database function. ![]() From what I read about it, It sounds like you can have a custom tool list and have separate speeds and feeds for different materials predefine kind of like you can with Gibbs CAM or Master CAM. I have not used it because we don’t have it, but I sure would like to give a try. You also have new Solid Graphics to preview your program before running. But you can turn the “show run time tool” on and you can watch the tool cut the part while the program is running on the screen.īut unless if you take the time to fill out the “stock material size” and “tool lengths geometry”, you will probably change the graphics settings back to wire frame like I did. I don’t know if it’s much use, but it sure is fun to watch. One new surprised I found oust is the tapping cycle. We had the Ulitmax 4 control on the HTX 500 and the tap cycle wasn’t that great like all the Ulitmax control. ![]() They took a huge step forward addressing this problem when we upgraded to the new WinMax control. Now the spindle doses not orientate between each hole and the threads comes out better, you can acutely thread a thread gauge into the hold by hand! Even with a 6-32 at 600 RPM! Unlike the Ulitmax control where I had to slow it down to 300 RPM and sill had two chase threads by hand afterwards.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |